iPECS UCP100 - Initialization Table - PGM 450

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
384
4.4.20.1 Initialization Table - PGM 450
Selecting Initialization will display the Initialization Table data entry page. Use the checkmark to indicate which
attributes to modify; data for checked attributes are initialized by clicking the [Initialize] button or reset the
system by clicking the [Reset System] button.
Figure 4.4.20.1-1 Initialization Menu
The system has been pre-programmed with certain features using the default data. The default data are
loaded into memory when the system is initialized. The system should always be initialized when first installed,
or the database appears corrupted.
In addition, the UCP system can be restarted from this page and, if redundant processors are equipped, the
active and standby UCP modules can be modified.
The system can be initialized manually during installation.
Note
If you reset the eMG system when Dip switch 2 is On, all databases will be initialized, including PGM 101-104.
If you reset the UCP system when Dip switch 4 is On, all databases will be initialized, including PGM 101-104.