iPECS UCP100 - Page 240

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
226
Table 4.4.6.3-3 RING GROUP ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Guar-Ann(Timer
0) Wait If Busy
When a call assigned to receive a guaranteed announcement
arrives and all channels are busy, the call may wait with
Ringback until a channel is available (ON) or bypass the
announcement. (OFF)
OFF
ON
ON
VSF Announce 2
Timer
After the 1st announcement, a 2nd announcement Timer is
activated. At expiration, if the call remains queued to the group,
the call is sent to the assigned 2nd VSF announcement.
000~999
(seconds)
000
VSF Announce 1
Location
Each Ring Group can be assigned an announcement, which is
played if the call remains queued beyond the VSF Announce 1
Timer duration. The announcement location is a VSF
Announcement number. An entry of 00 indicates no
announcement.
00~200
00: none
VSF Announce 1
Auto Drop
If this attribute is selected, the call will drop after the 1st VSF
announcement.
Check box
VSF Announce 2
Location
The Ring Group can be assigned a 2nd announcement, which is
played if the call remains queued beyond the VSF Announce 2
Timer duration. The announcement location is a VSF
Announcement number. An entry of 00 indicates no
announcement.
00~200
00: none
VSF announce
Auto Drop
If this attribute is selected, the call will drop after the 2nd VSF
announcement
Check box
VSF Announce 2
Repeat Timer
The 2nd announcement can be repeated to calls that remain in
the queue at the VSF Announce 2 Repeat Timer intervals. Note
VSF Announce 2 Repeat below must be “ON.”
000~999
(seconds)
000
VSF Announce 2
Repeat
After the 2nd announcement, if the call remains queued to the
group, the 2nd VSF announcement can be repeated at the VSF
Announce 2 Repeat Timer interval, defined above.
OFF
ON
OFF
Overflow
Destination
A call to the group will continue to ring group member stations
until answered. The call will remain at the last station or routes to
the assigned Overflow Destination. If VSF Announce is assigned,
Auto Drop is available.
 STA/NET or Station Group,
 VSF Announcement,
 Auto Drop,
 System SPD
Refer to
description
Overflow Timer
A call to a group will remain in the group or route to the assigned
Overflow Destination after the expiration of the Overflow Timer.
000~600
(seconds)
180
Wrap-Up Timer
After terminating the group call, a Station Group member will be
maintained in a busy state for the duration of the Wrap-Up Timer.
000~999
(seconds)
002