iPECS UCP100 - Page 598

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
157
Table 3.3.6.1-1 SYSTEM ATTRIBUTES I (PGM 160)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
7
HOLD PREFERENCE
(1: SYS/ 0: EXC) : SYS
A single depression of the[HOLD] button
during CO call places the call on the
preferred hold, System, or Exclusive.
0: Excl
1: System
System
8
PRINT LCR CONV DIGIT
(1 : LCR/ 0 : USER) : LCR
SMDR will output the number dialed by
either the system’s LCR or the user.
0: User
1: LCR
LCR
9
ATD CALL QUE AVAILABLE
(1:ON/0:OFF) : OFF
The system can be configured to queue
incoming calls to a busy Attendant.
0: OFF
1: ON
OFF
10
USE PGM_0 IN ALL ATTD
(1 : ON/ 0 : OFF) : OFF
This field allows the Main attendants
access to all Attendant functions,
including System Attendantfeatures and
programming.
(Except PGM 06 – Recordsystem
announcement)
0: OFF
1: ON
OFF
11
OFFNET PROMPT USAGE
(1 : ON/ 0 : OFF) : OFF
The Off-Net routing prompt can be played
when a call is routed to a destination
external to the iPECS. Not available in the
US version.
0: OFF
1: ON
OFF
12
CO-TO-CO UC TMR EXTEND
(1:ON/0:OFF) : OFF
When an UnsupervisedConference is
established with DISA, Off-Net Fwd, etc.,
the Unsupervised Conference timer(PGM
182-button 5determines the allowed
duration of the call. If enabled here, the
user may dial ‘#’ to extend the allowed
duration.
0: OFF
1: ON
OFF
13
ACD MANAGER PRINT
(1:ON/0:OFF) : OFF
When the optional ACDMessage events
are desired, the system must be enabled
to send ACD event messages.
0: OFF
1: ON
OFF
14
CALL LOG LIST NUM
(15-50) : 15
The Call Log that saves the Outgoing call
Received a call or Lost call information
can be displayed by pressing Call
LogDisplay Button. The maximum size of
the Call Log per station is defined here.
15~50
15
15
REPEAT DTMF TONE
(1:ON/0:OFF) : OFF
When enabled, the system will provide a
DTMF repeat tone to the caller’s station.
It’s nothing to do with PSTN.
0: OFF
1: ON
OFF