iPECS UCP100 - Page 86

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
72
Table 4.4.2.4-1 CLI Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Station CLI 1
To use this option, 'CLIR Service' or 'COLR Service' is set to
OFF. The CLI number is entered up to 12 digits. As a suffix,
the entered CLI number is added to the number set in
CLIP/COLP Table (201). Also check 'COLP Table Index', 'CLIP
Table Index', and 'Station CLI Type' in CID/CPN Attributes
(151).
The entered CLI number sends the called party via ISDN call
setup or connected message.
Default: eMG80/100:100, eMG800:1000, UCP:1000
Max. 12
digits
Refer to
description
Station CLI 2
To use this option, 'CLIR Service' or 'COLR Service' is set to
OFF. The CLI number is entered up to 16 digits. As a suffix,
the entered CLI number is added to the number set in
CLIP/COLP Table (201). Also check 'COLP Table Index', 'CLIP
Table Index', and 'Station CLI Type(2~5)' in CID/CPN
Attributes (151).The entered CLI number sends the called
party via ISDN call setup or connected message.
Max. 16
characters
Related
with PGM
143 –
Station CLI
Type
Station CLI 3
Station CLI 4
Station CLI 5
CLI / Redirect
Display
When an incoming call is redirected to the carrier’s network,
the SETUP message will contain an original and redirected
CLI. This selection determines if the iPECS IP and LDP Phone
will display the original or redirected number.
Original
CLI/
Redirect
CLI
Original CLI
Station or
Attendant
When the system sends a station number with CLIP or COLP,
the number can be either the Attendant number or the number
of the station.
Station
Attendant
Station
CPN Type
NOT SEND: CPN is not sent to the S0 interface.
STATION NUMBER: Station number is sent as CPN to S0
interface.
BYPASS FROM NET: Incoming CPN is sent as CPN to the S0
interface.
Refer to
description
Not send
CLI Name
Preference
NET: If the CLI name is provided from the network, then it is
displayed. If CLI name is not provided from the network, the
matched Speed name is displayed.
SPD: If CLI is matched with Speed bin and has a name, the
matched Speed name is displayed. If CLI is not matched or
matched Speed name is not configured, CLI name from the
network is displayed.
NET,
SPD
NET
Display Restricted
Caller Number
When {Display Restricted Caller Number} in CLI
Attributes(113) of a station is ON, although the caller number is
restricted in ISDN message, the ringing station displays the
caller number.
OFF
ON
OFF