• AC Power Supplies in an EX6200 Switch
• DC Power Supply in an EX6200 Switch
• AC Power Supply in an EX8200 Switch
• DC Power Supply in an EX8200 Switch
• AC Power Supply in an EX9204 Switch
• DC Power Supply in an EX9204 Switch
• AC Power Supply in an EX9208 Switch
• DC Power Supply in an EX9208 Switch
• AC Power Supply in an EX9214 Switch
• DC Power Supply in an EX9214 Switch
• Power Supply in an EX Series Redundant Power System
• AC Power Supply in OCX1100 Switches
• DC Power Supply in OCX1100 Switches
• AC Power Supply in a QFX3100 Director Device
• AC Power Supply in a QFX3008-I Interconnect Device
• Wiring Tray in a QFX3008-I Interconnect Device
• AC Power Supply for a QFX3500, QFX3600, or QFX3600-I Device
• DC Power Supply for a QFX3500, QFX3600, or QFX3600-I Device
• AC Power Supply for a QFX5100 Device
• DC Power Supply in a QFX5100 Device
Environmental Requirements and Specifications for EX Series Switches
The switch must be installed in a rack or cabinet housed in a dry, clean, well-ventilated,
and temperature-controlled environment.
Ensure that these environmental guidelines are followed:
•
The site must be as dust-free as possible, because dust can clog air intake vents and
filters, reducing the efficiency of the switch cooling system.
•
Maintain ambient airflow for normal switch operation. If the airflow is blocked or
restricted, or if the intake air is too warm, the switch might overheat, leading to the
switch temperature monitor shutting down the switch to protect the hardware
components.
Table 25 on page 60 provides the required environmental conditions for normal switch
operation.
59Copyright © 2015, Juniper Networks, Inc.
Chapter 4: Site Preparation