for highly cost-effective networking connectivity within a rack and between adjacent
racks. See Figure 12 on page 47.
Figure 12: SFP+ Direct Attach Cables for EX Series Switches
This topic describes:
•
Cable Specifications on page 47
•
Standards Supported by These Cables on page 51
Cable Specifications
EX Series switches support SFP+ passive direct attach cables. The passive Twinax cable
is a straight cable with no active electronic components. EX Series switches support 1 m,
3 m, 5 m, and 7 m long SFP+ passive direct attach cables.
Table 21 on page 47 describes the support for SFP+ passive direct attach cable lengths
on EX Series switches for Junos OS releases.
Table 21: Software Support for SFP+ Passive Direct Attach Cables for EX Series Switches
Cable LengthSoftware Support AddedSwitch
1 m (3 ft), 3 m (10 ft), 5 m (16 ft), and 7 m
(23 ft)
Junos OS Release 10.3EX3200 switches
1 m (3 ft), 3 m (10 ft), 5 m (16 ft), and 7 m
(23 ft)
Junos OS Release 10.3EX4200-24T, EX4200-24T-DC, EX4200-24P,
EX4200-24PX, EX4200-24F, EX4200-24F-DC,
EX4200-48T, EX4200-48T-DC, EX4200-48P,
and EX4200-48PX switches
1 m (3 ft), 3 m (10 ft), 5 m (16 ft), and 7 m
(23 ft)
Junos OS Release 12.3R4EX4200-24F-S and EX4200-48T-S switches
1 m (3 ft), 3 m (10 ft), 5 m (16 ft), and 7 m
(23 ft)
Junos OS Release 11.3EX3300 switches
1 m (3 ft), 3 m (10 ft), 5 m (16 ft), and 7 m
(23 ft)
Junos OS Release 13.2X50-D10EX4300-24T, EX4300-24P, EX4300-48T,
EX4300-48T-AFI, EX4300-48P,
EX4300-48T-DC, and EX4300-48T-DC-AFI
switches
1 m (3 ft) and 3 m (10 ft)Junos OS Release 13.2X51-D15EX4300-32F switches
1 m (3 ft), 3 m (10 ft), 5 m (16 ft), and 7 m
(23 ft)
Junos OS Release 13.2X51-D26EX4300-24T-S, EX4300-24P-S,
EX4300-48T-S,and EX4300-48P-S switches
1 m (3 ft) and 3 m (10 ft)Junos OS Release 13.2X51-D26EX4300-32F-S switches
47Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Component Specifications