Juniper EX3300

}
ge-0/1/2 {
unit 0 {
family ethernet-switching;
}
}
xe-0/1/2 {
unit 0 {
family ethernet-switching;
}
}
ge-0/1/3 {
unit 0 {
family ethernet-switching;
}
}
xe-0/1/3 {
unit 0 {
family ethernet-switching;
}
}
}
protocols {
igmp-snooping {
vlan all;
}
rstp;
lldp {
interface all;
}
lldp-med {
interface all;
}
}
ethernet-switching-options {
storm-control {
interface all;
}
}
poe {
interface all;
}
Related
Documentation
Configuration Files Terms•
• Connecting and Configuring an EX Series Switch (CLI Procedure) on page 119
• Understanding Configuration Files for EX Series Switches
• EX3300 Switches Hardware Overview on page 3
Connecting and Configuring an EX Series Switch (CLI Procedure)
There are two ways to connect and configure an EX Series switch: one method is through
the console by using the CLI and the other is by using the J-Web interface.
119Copyright © 2015, Juniper Networks, Inc.
Chapter 12: Performing Initial Configuration