Juniper SRX100B - Performing Initial Software Configuration on the SRX100 Services Gateway; Using the CLI

screen untrust-screen;
}
}
policies {
from-zone trust to-zone untrust {
policy trust-to-untrust {
match {
source-address any;
destination-address any;
application any;
}
then {
permit;
}
}
}
}
}
vlans {
vlan-trust {
vlan-id 3;
l3-interface vlan.0;
}
}
protocols {
stp;
}
Related
Documentation
SRX100 Services Gateway Autoinstallation Overview on page 42•
• Performing Initial Software Configuration on the SRX100 Services Gateway Using the
CLI on page 83
Performing Initial Software Configuration on the SRX100 Services Gateway Using the
CLI
This procedure connects the device to the network but does not enable it to forward
traffic. For complete information about enabling the device to forward traffic, including
examples, see Security Basics.
To configure the software:
1. Verify that the device is powered on.
2. Log in as the root user. There is no password.
3. Start the CLI.
root# cli
root@>
4. Enter configuration mode.
configure
[edit]
root@#
83Copyright © 2015, Juniper Networks, Inc.
Chapter 14: Performing Initial Configuration