CHAPTER 9
Installing the Mounting Hardware
•
Preparing the SRX100 Services Gateway for Rack-Mount Installation on page 47
•
Preparing the SRX100 Services Gateway for Desk-Mount Installation on page 48
•
Preparing the SRX100 Services Gateway for Wall-Mount Installation on page 48
Preparing the SRX100 Services Gateway for Rack-Mount Installation
You can mount an SRX100 Services Gateway in four-post (telco) racks, enclosed cabinets,
and open-frame racks.
NOTE: The SRX100 Services Gateway cannot be center-mounted in racks.
Before mounting the SRX100 Services Gateway in a rack:
•
Verify that the installation site meets the requirements described in the site preparation
checklist.
•
Verify that the racks or cabinets meet the specific requirements described in “SRX100
Services Gateway Rack Requirements” on page 26.
•
Place the rack or cabinet in its permanent location, allowing adequate clearance for
airflow and maintenance, and secure it to the building structure. For more information,
see “Clearance Requirements for Airflow and Hardware Maintenance of the SRX100
Services Gateway” on page 27.
•
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see “Unpacking the SRX100 Services Gateway” on page 43.
•
Verify that you have the following parts available in your rack-mounting kit for the
SRX100 Services Gateway:
•
Rack-mount tray
•
Screws
NOTE: The rack-mounting kit is not shipped with the device and must be
ordered separately.
47Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
