Juniper SRX100B - Chassis Description; SRX100 Services Gateway Built-In Interfaces; Table 9: SRX100 Services Gateway Built-In Hardware Interfaces

NOTE: The cable tie holder provides support for holding the power cord on
the power supply point.
The lock provides the option to lock and secure the device to the installation
site.
Related
Documentation
SRX100 Services Gateway Specifications on page 24•
• SRX100 Services Gateway Built-In Interfaces on page 15
• SRX100 Services Gateway LEDs on page 7
• SRX100 Services Gateway Boot Devices and Dual-Root Partitioning Scheme on page 11
• SRX100 Services Gateway Power Supply on page 10
SRX100 Services Gateway Built-In Interfaces
Table 9 on page 15 summarizes the interface ports supported on the SRX100 Services
Gateway.
Table 9: SRX100 Services Gateway Built-In Hardware Interfaces
DescriptionSpecificationsInterface Type
The Fast Ethernet ports can
be used:
•
To provide LAN connectivity
to hubs, switches, local
servers, and workstations.
•
To forward incoming data
packets to the device.
•
To receive outgoing data
packets from the device.
The Fast Ethernet ports:
•
Consist of eight fixed ports
•
Are labeled as port 0/0 to
port 0/7 on the front panel
•
Provide link speeds of
10/100 Mbps
•
Operate in full-duplex and
half-duplex modes
•
Support flow control
•
Support autonegotiation
•
Support autosensing
Fast Ethernet
15Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Chassis Description