CHAPTER 12
Connecting the SRX100 Services Gateway
to External Devices
•
Connecting and Organizing Interface Cables to the SRX100 Services
Gateway on page 61
•
Connecting the Modem at the SRX100 Services Gateway End on page 62
•
Connecting the Modem to the Console Port on the SRX100 Services Gateway on page 63
•
Connecting to the CLI at the User End for the SRX100 Services Gateway on page 63
Connecting and Organizing Interface Cables to the SRX100 Services Gateway
You can connect the interfaces installed in the services gateway to various network
media. Each type of interface on the services gateway uses a particular medium to
transmit data. You must configure each network interface before it can operate on the
device.
To connect and organize an interface cable for the device:
1. Have ready a length of the type of cable used by the interface.
2. Insert the cable connector into the cable connector port on the interface faceplate.
3. Arrange network cables as follows to prevent them from dislodging or developing
stress points:
•
Secure cables so that they are not supporting their own weight as they hang to the
floor.
•
Place excess cable out of the way in neatly coiled loops.
•
Use fasteners to maintain the shape of cable loops.
Related
Documentation
Connecting the SRX100 Services Gateway to the Power Supply on page 65•
• Grounding the SRX100 Services Gateway on page 57
• Interface Cable and Wire Specifications for the SRX100 Services Gateway on page 33
• SRX100 Services Gateway Installation Safety Guidelines and Warnings on page 125
61Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
