Juniper SRX100B - Monitoring the SRX100 Services Gateway Power System; Table 36: Services Gateway Power LED Status

• Juniper Networks Technical Assistance Center on page 103
Monitoring the SRX100 Services Gateway Power System
The LEDs on the services gateway enable you to determine the performance and
operation. The Power LED, located on the front panel of the services gateway, indicates
the different settings with respect to the power system.
Table 36 on page 101 describes different Power LED status settings and their corrective
actions.
Table 36: Services Gateway Power LED Status
Possible Cause and Corrective
ActionMeaningLED Status
Normal indication. No action is required.Device is receiving power,
and the internal power
supply is functional.
Green
Normal indication. No action is required.Indicates that the power
button has been pressed
and quickly released.
Amber
•
Verify that the AC power cord from
the power source to the device is not
damaged. If the insulation is cracked
or broken, immediately replace the
cord or cable.
•
Ensure that the socket you plug in is
in working condition.
•
Ensure the device has an AC input
voltage between 100 and 240 VAC.
•
If you cannot determine the cause
of the problem or need additional
assistance, see “Juniper Networks
Technical Assistance Center” on
page 103.
Indicates that the device
is not receiving power.
Off
Related
Documentation
Monitoring the SRX100 Services Gateway Chassis Using the CLI on page 95•
• Monitoring the SRX100 Services Gateway Components Using LEDs on page 97
• Monitoring the SRX100 Services Gateway Using Chassis Alarm Conditions on page 99
• Using the Reset Config Button on the SRX100 Services Gateway on page 102
• Changing the Reset Config Button Behavior on the SRX100 Services Gateway on
page 103
• Juniper Networks Technical Assistance Center on page 103
101Copyright © 2015, Juniper Networks, Inc.
Chapter 16: Troubleshooting Components