Juniper SRX100B - Table 35: SRX100 Services Gateway Chassis Alarm Conditions and Corrective

•
Monitoring and Troubleshooting for Security Devices
Table 35 on page 100 describes alarms that can occur for an SRX100 Services Gateway
chassis component.
Table 35: SRX100 Services Gateway Chassis Alarm Conditions and
Corrective Actions
Alarm
SeverityActionAlarm ConditionsComponent
Amber
(minor)
•
If the internal flash memory fails at
startup, the services gateway
automatically boots itself from the
alternative boot device (USB storage
device).
NOTE: If you configured your services
gateway to boot from an alternative
boot device, ignore this alarm
condition.
•
Reformat the internal flash memory
and install a bootable image. (See
theInitial Configuration for Security
Devices and Monitoring and
Troubleshooting for Security
Devices)
•
If you did not configure the services
gateway to boot from an alternative
boot device, contact JTAC. See
“Juniper Networks Technical
Assistance Center” on page 103.
The services gateway
boots from an alternate
boot device.
Boot media
Amber
(minor)
Check the room temperature. See
“SRX100 Services Gateway
Specifications” on page 24.
The services gateway
chassis temperature or
chassis is too warm
Hardware
components
on the
services
gateway
Red
(major)
The services gateway shuts down
automatically in 4 minutes.
The services gateway
temperature is too high,
either because of an
internal overheating
condition or because the
maximum recommended
room temperature has
been exceeded.
Related
Documentation
Monitoring the SRX100 Services Gateway Chassis Using the CLI on page 95•
• Monitoring the SRX100 Services Gateway Components Using LEDs on page 97
• Monitoring the SRX100 Services Gateway Power System on page 101
• Using the Reset Config Button on the SRX100 Services Gateway on page 102
• Changing the Reset Config Button Behavior on the SRX100 Services Gateway on
page 103
Copyright © 2015, Juniper Networks, Inc.100
SRX100 Services Gateway Hardware Guide for B and H Model Numbers