Juniper SRX100B - Table 34: Component Leds on the Services Gateway

Table 34: Component LEDs on the Services Gateway
Possible Causes and
Corrective ActionsMeaningStateLED
Normal condition. No action
is required.
Indicates that the device is
functioning normally.
GreenStatus LED
Normal condition. No action
is required.
•
Indicates that the device
is starting up.
•
Indicates that the Reset
Config button is pressed.
Amber
Contact JTAC. See “Juniper
Networks Technical
Assistance Center” on
page 103.
Indicates that an error is
detected in the device.
Red
Major alarm indicates a
critical situation on the
services gateway that
requires immediate action.
See “Monitoring the
SRX100 Services Gateway
Using Chassis Alarm
Conditions” on page 99.
Indicates a major alarm.RedAlarm LED
Minor alarm condition
requires monitoring or
maintenance. If left
unchecked, it might cause
an interruption in service or
degradation in
performance. See
“Monitoring the SRX100
Services Gateway Using
Chassis Alarm Conditions”
on page 99.
Indicates a minor alarm.Amber
Normal condition. No action
is required.
Indicates that there are
currently no alarms.
Off
Copyright © 2015, Juniper Networks, Inc.98
SRX100 Services Gateway Hardware Guide for B and H Model Numbers