CHAPTER 11
Grounding the SRX100 Services Gateway
•
Grounding the SRX100 Services Gateway on page 57
Grounding the SRX100 Services Gateway
To meet safety and electromagnetic interference (EMI) requirements and to ensure
proper operation, the SRX100 Services Gateway must be adequately grounded before
power is connected.
Figure 13 on page 57 illustrates how a grounding cable connects to the services gateway.
Figure 13: Grounding the SRX100 Services Gateway
You ground the device by connecting a grounding cable to earth ground and then attaching
it to the chassis grounding points using one M3 screw.
CAUTION: Before device installation begins, a licensed electrician must
attach a cable lug to the grounding and power cables that you use. A cable
with an incorrectly attached lug can damage the device (for example, by
causing a short circuit).
Table 24 on page 58 lists the grounding components of the SRX100 Services Gateway.
57Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
