user@host > show chassis fpc
Temp CPU Utilization (%) Memory Utilization (%)
Slot State (C) Total Interrupt DRAM (MB) Heap Buffer
0 Online -------------------- CPU less FPC --------------------
•
show chassis alarms
user@host > show chassis alarms
No alarms currently active
Related
Documentation
Monitoring the SRX100 Services Gateway Components Using LEDs on page 97•
• Monitoring the SRX100 Services Gateway Using Chassis Alarm Conditions on page 99
• Monitoring the SRX100 Services Gateway Power System on page 101
• Maintaining the SRX100 Services Gateway Hardware Components on page 93
• Using the Reset Config Button on the SRX100 Services Gateway on page 102
• Juniper Networks Technical Assistance Center on page 103
Monitoring the SRX100 Services Gateway Components Using LEDs
Table 33 on page 97 describes the status of the LEDs on startup of the device.
Table 33: Services Gateway LED Status on Startup
DescriptionStateLED
Indicates that the device is starting up.AmberStatus LED
Indicates that the device is starting up
for the first time since no rescue
configuration is set.
NOTE: When the system is up and
running, if the Alarm LED is off, it
indicates that no alarms are present on
the device.
AmberAlarm LED
Indicates that the device is receiving
normal power supply.
GreenPower LED
Indicates that the device is not part of
chassis clustering set up.
OffHA LED
The LEDs available on the services gateway display the status of various components.
Table 34 on page 98 describes the LEDs.
97Copyright © 2015, Juniper Networks, Inc.
Chapter 16: Troubleshooting Components
To Next Page
Loading...
