CAUTION: We recommend using a surge protector for the power connection.
NOTE: Use the cable tie holder to secure the power cord on to the power
supply point.
NOTE: We strongly recommend that you use only the 3-prong power cord
supplied with your services gateway. If you are using a 2-prong power cord,
then ensure that your device is adequately grounded using the grounding
point available on the back panel of the chassis.
Related
Documentation
Required Tools and Parts for Installing and Maintaining the SRX100 Services Gateway
on page 41
•
• Grounding the SRX100 Services Gateway on page 57
• Connecting and Organizing Interface Cables to the SRX100 Services Gateway on
page 61
• SRX100 Services Gateway General Safety Guidelines and Warnings on page 117
Powering On and Powering Off the SRX100 Services Gateway
This topic describes the following procedures:
•
Powering On the SRX100 Services Gateway on page 66
•
Powering Off the SRX100 Services Gateway on page 67
Powering On the SRX100 Services Gateway
To power on the services gateway:
1. Ensure that you have connected the power supply to the device.
2. Insert the plug of the power supply adapter into an AC power source receptacle.
3. Turn on the power to the AC power receptacle.
The device starts automatically as the power supply completes its startup sequence.
The Power LED lights during startup and remains on when the device is operating normally.
NOTE: After the power supply is turned on, it can take up to 60 seconds for
status indicators—such as the Status and Power LEDs—to show that the
power supply is functioning normally. Ignore error indicators that appear
during the first 60 seconds.
Copyright © 2015, Juniper Networks, Inc.66
SRX100 Services Gateway Hardware Guide for B and H Model Numbers
To Next Page
Loading...
