CHAPTER 14
Performing Initial Configuration
•
SRX100 Services Gateway Software Configuration Overview on page 69
•
Connecting to the SRX100 Services Gateway Setup Wizard on page 73
•
SRX100 Services Gateway Secure Web Access Overview on page 74
•
Connecting an SRX100 Services Gateway to the CLI Locally on page 75
•
Connecting an SRX100 Services Gateway to the CLI Remotely on page 76
•
Viewing Factory-Default Settings of the SRX100 Services Gateway on page 77
•
Performing Initial Software Configuration on the SRX100 Services Gateway Using the
CLI on page 83
•
Performing Initial Software Configuration on the SRX100 Services Gateway Using the
J-Web Interface on page 86
•
Upgrading the SRX100 Services Gateway Low Memory Version to a High Memory
Version on page 90
SRX100 Services Gateway Software Configuration Overview
This topic includes the following sections:
•
Preparing the SRX100 Services Gateway for Configuration on page 69
•
Understanding the Factory Default Configuration on page 70
•
Understanding Built-In Ethernet Ports and Initial Configuration on page 70
•
Mapping the Chassis Cluster Ports on page 71
•
Understanding Management Access on page 72
Preparing the SRX100 Services Gateway for Configuration
The Juniper Networks Junos operating system (Junos OS) is preinstalled on the SRX100
Services Gateway. When the services gateway is powered on, it is ready to be configured.
You can perform the initial software configuration of the services gateway by using either
the browser-based setup wizard or the command-line interface (CLI).
Before configuring the device, gather the configuration information required to deploy
the device in your network. At minimum, the setup wizard requires the following
information:
69Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
