TIP: When you are powering off the device, the CLI displays the following
message: Turning the system power off. You can now safely remove the power
cable to completely power off the device.
NOTE: You can use the request system reboot CLI command to schedule a
reboot to the services gateway using request system reboot.
For more information about halting, powering off, or rebooting the services gateway using
the CLI, see the following topics:
•
Initial Configuration for Security Devices
•
Monitoring and Troubleshooting for Security Devices
Related
Documentation
• Connecting the SRX100 Services Gateway to the Power Supply on page 65
• Grounding the SRX100 Services Gateway on page 57
• Using the Reset Config Button on the SRX100 Services Gateway on page 102
• Changing the Reset Config Button Behavior on the SRX100 Services Gateway on
page 103
Copyright © 2015, Juniper Networks, Inc.68
SRX100 Services Gateway Hardware Guide for B and H Model Numbers
To Next Page
