• SRX100 Services Gateway Secure Web Access Overview on page 74
Upgrading the SRX100 Services Gateway Low Memory Version to a High Memory
Version
Based on your requirements, you can upgrade from an SRX100 Services Gateway Low
Memory version to a High Memory version through a license key. You need not order a
separate High Memory device.
The double-data-rate (DDR) memory allocation in the SRX100 Services Gateway is as
follows:
•
SRX100 Services Gateway High Memory - 1 GB
•
SRX100 Services Gateway Low Memory - 512 MB
All SRX100 Services Gateways have a built-in DDR memory of 1 GB. The SRX100 Services
Gateway Low Memory devices can utilize a maximum of 512 MB of DDR memory. To
utilize 1 GB of DDR memory, you must upgrade your device to an SRX100 Services Gateway
High Memory version by installing the memory upgrade license. You can install the memory
license using the CLI configuration editor.
For more information, see the following guides:
•
Initial Configuration for Security Devices
•
Monitoring and Troubleshooting for Security Devices
NOTE: When you install the memory upgradelicense on an SRX100 Services
Gateway Low Memory device, the device reboots automatically. When the
device is active again, it will function as a High Memory device.
NOTE: The memory upgrade license is a perpetual license. You can activate
this feature on the device by directly entering the license key (provided by
the licensing management system) in the CLI.
For more information on generating, installing, and managing licenses, see the following
guides:
•
Initial Configuration for Security Devices
•
Monitoring and Troubleshooting for Security Devices
To obtain a memory license, contact your Juniper Networks customer services
representative.
Related
Documentation
• SRX100 Services Gateway Features and Functions on page 4
• SRX100 Services Gateway Specifications on page 24
Copyright © 2015, Juniper Networks, Inc.90
SRX100 Services Gateway Hardware Guide for B and H Model Numbers
To Next Page
Loading...
