Table 31: Optional Setup Fields (continued)
Your ActionFunctionField
Use buttons to add, edit, or
delete VLANs
Interface Groups (VLANs)
Use buttons to add, edit, or
delete interfaces other than
VLANs.
NOTE: Make sure that you
have selected the required
services and protocols under
Services (Inbound) and
Protocols (Inbound). Select all
to permit all protocols and
services.
Configure Interfaces
Configure System: Time
Use Reset Manually button to
reset time.
Current System Time
Choose the time zone fromthe
list
Time Zone
Add Network Time Protocol
(NTP) servers that the gateway
can reach to synchronize the
system time.
NTP Servers
After you configure the basic setup, the Setup wizard is no longer available, unless you
reset the device to the factory default and reboot it. To make changes to the configuration,
use the J-Web interface or the command-line interface (CLI).
You can use other wizards to configure basic firewall policies, VPN settings, and NAT
rules. Choose Configure > Wizards to use the available wizards. Use the J-Web interface
or the CLI for more extensive configuration.
For more instructions on managing users and operations, monitoring network performance,
upgrading software, and diagnosing common problems on an SRX100 Series Services
Gateways, see the following guides:
•
Initial Configuration for Security Devices
•
Monitoring and Troubleshooting for Security Devices
Related
Documentation
Connecting to the SRX100 Services Gateway Setup Wizard on page 73•
• SRX100 Services Gateway Software Configuration Overview on page 69
• Performing Initial Software Configuration on the SRX100 Services Gateway Using the
CLI on page 83
89Copyright © 2015, Juniper Networks, Inc.
Chapter 14: Performing Initial Configuration
To Next Page
Loading...
