Related
Documentation
Unpacking the SRX100 Services Gateway on page 43•
• Clearance Requirements for Airflow and Hardware Maintenance of the SRX100 Services
Gateway on page 27
• SRX100 Services Gateway Rack Requirements on page 26
• Preparing the SRX100 Services Gateway for Desk-Mount Installation on page 48
• Preparing the SRX100 Services Gateway for Wall-Mount Installation on page 48
Preparing the SRX100 Services Gateway for Desk-Mount Installation
You can mount an SRX100 Services Gateway on a desk or other level surface horizontally
or vertically. The four rubber feet attached to the chassis provide stability.
Before mounting an SRX100 Services Gateway on a desk or other level surface:
•
Verify that the site meets the requirements described in the site preparation checklist.
•
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
•
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see “Unpacking the SRX100 Services Gateway” on page 43.
•
If you are mounting the device vertically on the desk, make sure that the following parts
are available in your vertical desk-mounting kit for the SRX100 Services Gateway:
•
Vertical stand
•
Screws
NOTE: The vertical desk-mounting kit is not shipped with the device and
must be ordered separately.
Related
Documentation
Unpacking the SRX100 Services Gateway on page 43•
• Clearance Requirements for Airflow and Hardware Maintenance of the SRX100 Services
Gateway on page 27
• Preparing the SRX100 Services Gateway for Rack-Mount Installation on page 47
• Preparing the SRX100 Services Gateway for Wall-Mount Installation on page 48
Preparing the SRX100 Services Gateway for Wall-Mount Installation
You can mount an SRX100 Services Gateway on a wall. The four rubber feet attached
to the chassis provide stability.
Copyright © 2015, Juniper Networks, Inc.48
SRX100 Services Gateway Hardware Guide for B and H Model Numbers
To Next Page
Loading...
