Juniper SRX100B - Page 67

Before mounting an SRX100 Services Gateway on a wall:
•
Verify that the site meets the requirements described in “Site Preparation Checklist
for the SRX100 Services Gateway” on page 21.
•
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see “Unpacking the SRX100 Services Gateway” on page 43.
•
Verify that you have the following parts available in your wall-mounting kit for the
SRX100 Services Gateway:
•
Wall-mounting brackets
•
Screws
NOTE: The wall-mounting kit is not shipped with the device and must be
ordered separately.
Related
Documentation
• Site Preparation Checklist for the SRX100 Services Gateway on page 21
• Unpacking the SRX100 Services Gateway on page 43
• Clearance Requirements for Airflow and Hardware Maintenance of the SRX100 Services
Gateway on page 27
• Preparing the SRX100 Services Gateway for Rack-Mount Installation on page 47
• Preparing the SRX100 Services Gateway for Desk-Mount Installation on page 48
49Copyright © 2015, Juniper Networks, Inc.
Chapter 9: Installing the Mounting Hardware