KEB F6 - Page 219

Parameter Descriptions
© 2024 KEB America, Inc.
219
Description
Value
Motor Contactor engaged
366
Motor Contactor Configuration Error
367
Motor Contactor reserved
368-370
Fieldbus Watchdog expired
450
Fieldbus Dropped Enable
451
Fieldbus Command Speed Error
452
Fieldbus reserved
453-454
Auto fault reset
455
Manual fault reset
456
Manual fault reset required
457
Forced fault reset
458
Forced fault reset required
459
Fault reset reserved
460-463
Config File Error - Reboot Req. to
Clear
777
Assert_e Failure - Reboot Req. To
Clear
790
LIFT_EVENT_END
998
RU01_VFD_START
999
no exception
1000
ERROR chain
1001
ERROR supply
1002
ERROR overcurrent PU
1003
ERROR overcurrent analog
1004
ERROR overpotential
1005
ERROR underpotential
1006
ERROR overload
1007
reset E. overload
1008
ERROR overload 2
1009
ERROR overheat powmod.
1010
reset E. overheat pmod.
1011
ERROR overheat internal
1012
reset E. overheat intern
1013
ERROR motorprotection
1014
reset E. motorprotection
1015
ERROR drive overheat
1016
reset E. drive overheat
1017
ERROR overspeed
1018
Description
Value
reserved
1019
ERROR drive data
1020
ERROR motordata not stored
1021
ERROR ident
1022
ERROR diff speed
1023
ERROR fieldbus memory
1024
reserved
1025-
1026
WARNING overload
1027
reset W. overload
1028
WARNING overload 2
1029
WARNING overheat powmod.
1030
reset W. overheat pmod.
1031
WARNING overheat intern.
1032
reset W. overheat intern
1033
WARNING motorprotection
1034
reset W. motorprotection
1035
WARNING drive overheat
1036
reset W. drive overheat
1037
ERROR memory size
1038
reserved
1039
ERROR FPGA conf.
1040
ERROR safety mod. SACB comm.
1041
ERROR power unit SACB comm.
1042
ERROR enc.intf. SACB comm.
1043
ERROR invalid power unit data
1044
ERROR power unit reset
1045
ERROR power unit Vref
1046
ERROR power unit flash
1047
ERROR power unit prog.
1048
reserved
1049-
1051
ERROR undervoltage phase
1052
reserved
1053-
1054
ERROR safety module
1055
ERROR software switch left
1056
ERROR software switch right
1057