Positioning Parameters (LP): LP01...LP23
These parameters contain the adjustments needed for the drive positioning control.
Outputs Parameters (LO): LO01...LO32
These parameters define the functionality of the relay and solid-state drive outputs.
Diagnostics Parameters (DG): DG01...DG99 (Combivis only)
These parameters display diagnostics and status of the drive and are only viewable in
Combivis. However, many are viewable in the Diagnostics Screens.
Field Bus Parameters (FB): FB01...FB55
These parameters define the settings for control with serial communication data.
Terminal Slowdown Parameters (TS): TS01...TS08
These parameters define the settings for NTSD inputs and speed thresholds.
Analog I/O Parameters (LA): TS01...TS08
These parameters define and adjust the analog inputs and outputs.
To Next Page
Loading...
