Keithley 2000 User Manual

:MUNits
:CALCulate [1]:KMATh:MUNits <name> Specify units for mx+b
Parameter <name> = 3 characters using ‘A’ through ‘Z’
Query :MUNits? Query units for mx+b
Description This command is used to specify the units data element for the mx+b calcu-
lation. Use any three letters from ‘A’ through ‘Z’.
:PERCent <NRf>
:CALCulate [1]:KMATh:PERCent <NRf> Specify target value for percent calculation
Parameter <Nrf> = -1e8 to +1e8 Specify target value.
Query :PERCENt? Query percent target value
Description This command is used to specify the target value for the percent calculation.
:ACQuire
:CALCulate [1]:KMATh:PERCent:ACQuire Use input signal as target value
Description This action command is used to acquire the present input signal reading and
use it as the target value for the Percent calculation.
:STATe <b>
:CALCulate [1]:STATe <b> Control CALC1
Parameters <b> = 0 or off Disable CALC1 calculation
1 or on Enable CALC1 calculation
Query :STATe? Query state (on or off) of CALC1.
Description This command is used to enable or disable the CALC1 calculation. When
enabled, each instrument reading will reflect the selected calculation (see
:FORMat).
:DATA?
:CALCulate [1]:KMATh:DATA? Read CALC1 result
Description This query command is used to read the result of the CALC1 calculation. If
CALC1 is disabled or NONE is selected, the “raw” reading will be read.
SCPI Command Reference 5-21

Keithley 2000 Specifications

General

Brand	Keithley
Model	2000
Category	Multimeter
Language	English