:CALCulate2
These commands are used to configure and control the CALC2 operations on
readings stored in the buffer.
:FORMat <name>
CALCulate2:FORMat <name> Specify CALC2 format
Parameters <name> = NONE No calculations
MEAN Mean value of readings in buffer
SDEViation Standard deviation of readings in buffer
MAXimum Largest reading in buffer
MINimum Lowest reading in buffer
Query :FORMat? Query programmed math format
Description This command is used to specify the format for the CALC2 math calculation.
The calculation operations for CALC2 use data stored in the buffer.
With NONE selected, no CALC2 calculation is performed. With any of the
other formats selected and CALC2 enabled (see :STATe), the calculation is
performed every time the :IMMediate or :IMMediate? command is executed.
:STATE <b>
:CALCulate2:STATe <b> Control CALC2
Parameters <b> = 0 or off Disable CALC2 calculation
1 or on Enable CALC2 calculation
Query :STATe? Query state (on or off) of CALC2.
Description This command is used to enable or disable the CALC2 calculation. When
enabled, the selected CALC2 format will be calculated when the :IMMediate
or :IMMediate? command is executed.
5-22 SCPI Command Reference
To Next Page
Loading...
Need help?
General
