IEEE-488 Reference
3-62
Table 3-13
SYSTem command summary
Command Description
Default
parameter SCPI Ref
:SYSTem
:PRESet
:POSetup <name>
:POSetup?
:FRSWitch?
:VERSion?
:ERRor?
:AZERo
:TYPE <name>
:TYPE?
:STATe <b>
:STATe?
:AMEThod <name>
:AMEThod?
:LSYNc
:STATe <b>
:STATe?
:KEY <NRf>
:KEY?
:CLEar
:LFRequency?
:DATE <yr>, <mo>, <day>
:DATE?
:TIME <hr>, <min>, <sec>
:TIME?
:TSTamp
:TYPE <name>
:TYPE?
:RELative
:RESet
:RNUMber
:RESet
Return to :SYST:PRES defaults.
Select power-on setup: (RST, PRESet or SAV0-SAV9).
Query power-on setup.
Query INPUTS switch (0 = rear, 1 = front).
Query rev level of SCPI standard.
Query (read) Error Queue.
Path to set up autozero.
Select autozero mode: (NORMal or SYNChronous).
Query autozero mode.
Enable or disable autozero.
Query autozero.
Select reading acquisition method: (BURSt, NORMal,
ASTReam or SSTReam).
Query acquisition method.
Path to control line synchronization of measurements.
Enable or disable line sync.
Query line sync.
Simulate key-press (1 to 31; see Figure 3-39).
Query the last “pressed” key.
Clears messages from the Error Queue.
Query frequency of line power.
Set date.
Query date.
Set time (24-hour format).
Query time.
Path to configure and control timestamp.
Select timestamp type (RELative or RTClock).
Query timestamp type.
Path to reset timestamp.
Reset relative timestamp to 0 sec.
Path to reset reading number.
Reset reading number ot zero.
(Note)
SYNC
ON
NORMal
OFF
√
√
√
√
√
3.21.1
3.21.2
3.21.3
3.21.4
3.21.5
3.21.6
3.21.7
3.21.8
3.21.9
3.21.10
3.21.11
3.21.12
3.21.13
3.21.14
3.21.15
Note: Clearing the Error Queue: Power-up and *CLS – Clears the Error Queue
*RST, :SYSTem:PRESet and :STATus:PRESet – No effect
To Next Page
Loading...
Need help?
General
