Keithley 2002 User Manual

IEEE-488 Reference
3-84
3.15 :INPut subsystem
The :INPut subsystem is used for the Model 1801 Nanovolt Preamp. These commands are sum-
marized in Table 3-7.
:PREamp Commands
The :PREamp commands are used to control the Model 1801 Nanovolt Preamp card. Refer to
the Model 1801 instruction manual for detailed operating information.
:STATe <b>
:INPut:PREamp:STATe <b> Enable or disable preamp
<b> = 1 or ON Enable preamp
0 or OFF Disable preamp
:STATe? Query state of preamp
With the Model 1801 installed in the option slot, this command is used to enable or disable
preamp.
PRINT #1, "output 16; :inp:pre:stat on" ' Enable preamp
PRINT #1, "enter 16" ' Get response from 2002
:FILTer <name>
:INPut:PREamp:FILTer <name> Select filter response
<name> = SLOW Select slow filter response
MED Select medium filter response
FAST Select fast filter response
:FILTer? Query selected filter response
This command is used to select the filter response for the preamp. Note that only the FAST
response is available for the ACV and FREQ functions.
PRINT #1, "output 16; :inp:pre:filt fast" ' Select FAST filter response
PRINT #1, "enter 16" ' Get response from 2002
Parameters
Query
Description
Program fragment
Parameters
Query
Description
Program fragment

Keithley 2002 Specifications

General

Resolution	8.5 digits
DC Voltage Accuracy	±0.0006%
Maximum DC Voltage	1000 V
Maximum AC Voltage	750 V
Maximum DC Current	3 A
Maximum AC Current	3 A
Connectivity	GPIB, RS-232
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
Resistance Range	10 Ω to 1 GΩ
Model	2002
Category	Multimeter
Interface	GPIB, RS-232
AC Current Accuracy	±0.1%
Frequency Range	0.1Hz to 300kHz
Display	VFD
Type	Digital
Power Supply	100-240V AC, 50/60Hz
Current Range (DC)	100 μA to 3 A
Current Accuracy (DC)	±0.01%
Current Range (AC)	100 μA to 3 A
Current Accuracy (AC)	±0.1%
DC Current Range	100 μA to 3 A
AC Current Range	100 μA to 3 A