Name: Keithley 2002
Brand: Keithley
Rating: 4 (1 reviews)

To Next Page

To Previous Page

HP3458A Emulation Mode

H-1

Introduction

This appendix provides detailed information on using the

Model 2002 HP3458A emulation mode. The emulation

mode gives the Model 2002 a high degree of compatibility

with the Hewlett-Packard HP3458A Digital Multimeter,

allowing the instrument to be substituted for an HP3458A in

an existing measurement system with little or no program

modiﬁcations.

Firmware revision level

The HP3458A emulation mode is available in Model 2002s

equipped with revision A05 and later main processor ﬁrm-

ware. The ﬁrmware revision level is displayed during the

power-up cycle and may be displayed at any time by using

the GENERAL/ SERIAL # selection in the main MENU.

Enabling the HP3458A emulation mode

The HP3458A emulation mode may be enabled from the

front panel by using the LANGUAGE selection in the GPIB

menu as follows:

1. Press the MENU key to display the main menu.

2. Select GPIB, then press ENTER.

3. Select LANGUAGE, then press ENTER.

4. Choose HP3458-EMULATION, then press ENTER.

5. Enable or disable the emulation mode as desired, then

press ENTER to complete your selection.

6. Press EXIT as required to return to normal display.

Unsupported commands

Table H-1 summarizes commands not supported by the

Model 2002 HP3458A emulation mode.

Other manuals for Keithley 2002

Questions and Answers:

Need help?

Do you have a question about the Keithley 2002 and is the answer not in the manual?

General