Name: Keithley 2002
Brand: Keithley
Rating: 4 (1 reviews)

To Next Page

To Previous Page

IEEE-488 Reference

3-136

Note: To disable all messages from entering the Error Queue, send the following command:

:stat:que:enab ()

PRINT #1, "output 16; :stat:que:enab (0:999); enab?" ' Enable all messages

and query

PRINT #1, "enter 16" ' Get response message

from 2002

DISable <list>

:STATus:QUEue:DISable <list> Disable messages for Error Queue

<list> = (numlist)

where; numlist is a speciﬁed list of messages that you wish to disable for the Error Queue.

:DISable? Query list of disabled messages

On power-up, all error messages are enabled and will go into the Error Queue as they occur. Sta-

tus messages are not enabled and will not go into the queue. This command is used to specify

which messages you want disabled. Disabled messages are prevented from going into the Error

Queue.

Messages are speciﬁed by numbers (see Table 2-4). See :QUEue:ENABle for examples to ex-

press a numlist.

PRINT #1, "output 16; :stat:que:dis (-140:-150); dis?" ' Disable messages

and query

PRINT #1, "enter 16" ' Get response mes-

sage from 2002

:CLEar

:STATus:QUEue:CLEar Clear Error Queue

This action command is used to clear the Error Queue of messages.

PRINT #1, "output 16; :stat:que:cle" ' Clear Error Queue

Program fragment

Parameters

Query

Description

Program fragment

Description

Program fragment

Other manuals for Keithley 2002

Questions and Answers:

Need help?

Do you have a question about the Keithley 2002 and is the answer not in the manual?

General