5: SCPI command reference Series 2230G Triple-Channel Power Supplies
5-8 2230G-900-01 Rev. A / June 2018
*SRE
This command sets or queries the bits in the Status Byte Enable Register. Setting this parameter can determine
which byte of the Status Byte Register has a value of 1. The byte sets the RQS bit of the Status Byte Register
to 1. The bit definition of the Status Byte Enable Register is as the same as the Status Byte Register.
Group
Status
Syntax
*SRE <NR1>
*SRE?
Arguments
<NR1> An integer value 0 to 255. The binary bits of the Status Request Enable Register (SRER) are
set according to this value. Using an out-of-range value causes an execution error.
Default value
The power-on default for the SRER is 0 if the *PSC command is set to 1. If the *PSC command is set
to 0, the SRER maintains its value through a power cycle.
Returns
An integer value from 0 to 255.
Example
*SRE 48
Sets the bits in the SRER to a binary value of 00110000.
*SRE?
Might return a value of 32, which means the bits in the SRER have the binary value 00100000.
See also
*CLS (on page 5-2)
*ESR? (on page 5-3)
*PSC (on page 5-5)
To Next Page
Loading...
Need help?
General
