Keysight M8070A Programming Guide 117
SCPI Command Reference 5
:STATus:QUEStionable:INSTrument:PTRansition[?]
Syntax :STATus:QUEStionable:INSTrument:PTRansition[?] <NRf>
Input
Parameters
<NRf>: Set transition filter state.
Description This command sets the transition filter state in the Questionable Status
Register structure. The query returns the weighted value of the bits that
are set to pass positive transitions in the transition filter.
:STATus:QUEStionable:PROTection
The summary bit of this register set is reflected in bit 11 of the
Questionable Status Register.
The :STATus:QUEStionable:PROTection contains conditions which reflect
states of the instrument’s normal operation. These are summary bits. For
example, if one or more outputs of the instrument detect an overload
condition, the OverloadDetection bit will be set.
The definition of each of these bits (condition register) is as follows:
Bit 0 - OverloadDetection
Indicates that an overload condition has been detected.
:STATus:QUEStionable:PROTection:CONDition?
Syntax :STATus:QUEStionable:PROTection:CONDition?
Description This command returns the contents of the condition register of the
Questionable Status Register (bit 11) to detect an overload condition.
:STATus:QUEStionable:PROTection:ENABle[?]
Syntax :STATus:QUEStionable:PROTection:ENABle <NRf>
:STATus:QUEStionable:PROTection:ENABle?
Description This command sets the bits in the event enable register that can generate
a summary bit used for monitoring a symbol alignment loss. The query
returns the weighted value of the bits that are set in the event enable
register.
To Next Page
Loading...
Need help?
General
