Keysight M8070A Programming Guide 123
SCPI Command Reference 5
:STATus:OPERation:PTRansition[?]
Syntax :STATus:OPERation:PTRansition <NRf>
:STATus:OPERation:PTRansition?
Input
Parameters
<NRf>: Set transition filter state.
Description This command sets the transition filter state in the Operation Status
Register structure. This is the default setting of the instrument. The query
returns the weighted value of the bits that are set to pass positive
transitions in the transition filter.
:STATus:OPERation:RUN
The summary bit of this register set is reflected in bit 8 of the Operation
Status Register.
The :STATus:OPERation:RUN contains conditions which reflect states of
the instrument’s normal operation. These are summary bits. For example,
if the pattern generators, error detectors and clock generator are
functioning normally, the Running bit will be set.
The definition of each of these bits (condition register) is as follows:
Bit 0 - Running
Indicates that the instrument is in normal operation mode; generators are
working, all error detectors are running and the clock generator is
functioning properly.
:STATus:OPERation:RUN:CONDition?
Syntax :STATus:OPERation:RUN:CONDition?
Description This command returns the contents of the condition register of the
Operation Status Register (bit 8) to detect if all components are operating
normally.
To Next Page
Loading...
Need help?
General
