Keysight M8070A Programming Guide 155
SCPI Command Reference 5
[:SOURce]:JITTer:HFRequency:PERiodic Subnode
This subnode has the following SCPI structure:
This subnode has the following commands:
Table 36
[:SOURce]:JITTer:HFRequency:PERiodic(*)[:STATe][?]
Syntax [:SOURce]:JITTer:HFRequency:PERiodic(*)[:STATe] ‘identifier’,
<ON|OFF|1|0>
[:SOURce]:JITTer:HFRequency:PERiodic(*)[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: 'M1.ClkOut', 'M*.DataOut1', 'M*.DataOut2', or 'M*.DataOut'
<ON|OFF|1|0>: Enable/disable periodic jitter.
Return Range 1|0
Description This command is used to enable/disable periodic jitter high frequency
output at the given location.
Name Description under
[:STATe][?] [:SOURce]:JITTer:HFRequency:PERiodic(*)[:
STATe][?] on page 155
:AMPLitude[?] [:SOURce]:JITTer:HFRequency:PERiodic(*):
AMPLitude[?] on page 156
:FREQuency[?] URce]:JITTer:HFRequency:PERiodic(*):FRE
Quency[?] on page 157
To Next Page
Loading...
