Keysight Technologies J-BERT M8020A - Page 164

164 Keysight M8070A Programming Guide
5 SCPI Command Reference
Input
Parameters
‘identifier’: 'M*.DataOut1', 'M*.DataOut2', or ‘M*.DataOut’
<OFF|LP100|LP500>: Enable/disable low-pass filter.
Return Range OFF|LP100|LP500
Description This command enables/disables the low-pass filter for random jitter.
LP100 enables a 100 MHz low-pass filter; LP500 enables a 500 MHz
low-pass filter.
This query returns the current settings.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8045A.
Example :JITT:HFR:RAND:FILT ‘M1.DataOut2’, LP100
[:SOURce]:JITTer:HFRequency:RANDom:FILTer[:LPASs]:VALue[?]
Syntax [:SOURce]:JITTer:HFRequency:RANDom:FILTer[:LPASs]:VALue
<identifier>,<NRf>
[:SOURce]:JITTer:HFRequency:RANDom:FILTer[:LPASs]:VALue?
<identifier>
Input
Parameters
‘identifier’: 'M*.DataOut1', 'M*.DataOut2', M*.DataOut3, M*.DataOut3, or
‘M*.DataOut’
<NRf>
Return Range 1 MHz to 10 GHz
The limit is dynamic, it depends on the high-pass setting.
Description This command controls the low pass filter of the random jitter source.
This query returns the current settings.
This SCPI is applicable for M8195A and M8196A.
Example :JITT:HFR:RAND:FILT:LPAss:VALue ‘M1.DataOut2’,1e6
[:SOURce]:JITTer:HFRequency:RANDom:FILTer:HPASs[?]
Syntax [:SOURce]:JITTer:HFRequency:RANDom:FILTer:HPASs ‘identifier’
<OFF|HP10>
[:SOURce]:JITTer:HFRequency:RANDom:FILTer:HPASs? ‘identifier’