Keysight M8070A Programming Guide 171
SCPI Command Reference 5
[:SOURce]:JITTer:LFRequency:PERiodic Subnode
This subnode has the following SCPI structure:
This subnode has the following commands:
Table 41
[:SOURce]:JITTer:LFRequency:PERiodic[:STATe][?]
Syntax [:SOURce]:JITTer:LFRequency:PERiodic[:STATe] ‘identifier’, <ON|OFF|1|0>
[:SOURce]:JITTer:LFRequency:PERiodic[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: 'M1.ClkOut', 'M*.DataOut1', 'M*.DataOut2', or 'M*.DataOut'
<ON|OFF|1|0>: Enable/disable the low frequency periodic jitter source.
Return Range 1|0
Name Description under
[:STATe][?] [:SOURce]:JITTer:LFRequency:PERiodic[:ST
ATe][?] on page 171
:AMPLitude[?] [:SOURce]:JITTer:LFRequency:PERiodic:AM
PLitude[?] on page 172
:FREQuency[?] [:SOURce]:JITTer:LFRequency:PERiodic:FR
EQuency[?] on page 172
To Next Page
Loading...
