Keysight Technologies J-BERT M8020A - Page 236

236 Keysight M8070A Programming Guide
5 SCPI Command Reference
:INPut:DRATe?
Syntax :INPut:DRATe? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataIn1', 'M*.DataIn2' or 'M*.DataIn'
Description This query returns the data rate for the input channel.
This SCPI is applicable for M8061A M8062A and M8046A.
Example :INP:DRAT? 'M1.DataIn1'
:INPut:DELay[?]
Syntax :INPut:DELay ‘identifier’, <NRf>
:INPut:DELay? ‘identi
fier’
Input
Parameters
‘identifier’: 'M*.DataIn1', 'M*.DataIn2', or 'M*DataIn'
<NRf>: Specify sampling edge delay value.
Return Range For M8041A, M8051A and M8046A: -6.7 ns to +6.7 ns
For M8061A: 0 ps to 60 ps
For M8062A: -10 ns to 10 ns
For M8046A: -6.7 ns to 6.7 ns
Description This command specifies the delay of the sampling edge.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.
Example :INP:DEL ‘M1.DataIn1’, 1e-9
:INPut:EQUalization[
:PREset][?]
Syntax :INPut:EQUalization[:PREset] 'Identifier', <OFF | P1 | P2 | P3 | P4 | P5 | P6 |
P7 | P8 | P9 | P10>
:INPut:EQUalization[:PREset]? 'Identifier',
Input
Parameters
‘identifier’: 'M*.DataIn1' or 'M*.DataIn2'
<OFF | P1 | P2 | P3 | P4 | P5 | P6 | P7 | P8 | P9 | P10>