Keysight M8070A Programming Guide 237
SCPI Command Reference 5
Return Range OFF | P1 | P2 | P3 | P4 | P5 | P6 | P7 | P8 | P9 | P10
Description This command is used to select from the following equalization presets:
For M8041A and M8051A:
• OFF - Disables equalization
• P1 - PCIe 8Gb/s -6 dB
• P2 - PCIe 8Gb/s -9 dB
• P3 - PCIe 8Gb/s -12 dB
• P4 - USB 5Gb/s -3.5 dB
• P5 - PCIe 16Gb/s -6 dB
• P6 - PCIe 16Gb/s -9 dB
• P7 - PCIe 16Gb/s -12 dB
• P8 - USB 10Gb/s 0 dB
• P9 - USB 10Gb/s -3 dB
• P10 - USB 10Gb/s -6 dB
For M8061A:
•OFF - off
• P1 - PCIe 8Gb/s -6 dB
• P2 - PCIe 8Gb/s -9 dB
• P3 - PCIe 8Gb/s -12 dB
• P4 - USB 5Gb/s -3.5 dB
For M8062A:
•P1 - Low
•P2 - Medium
• P3 - High
The availability of individual presets depe
nds on the type of module being
controlled and the calibration status of the respective module.
This SCPI is applicable for M8041A, M8051A, M8061A and M8062A.
For M8062A, the equalizer is available only for 20 Gb/s and higher. For
other values, if a command is sent, it will return OFF and will notify that the
value is read-only.
Example :INP:EQU ‘M1.DataIn1’,P1
To Next Page
Loading...
