Keysight M8070A Programming Guide 287
SCPI Command Reference 5
:PLUGin:ERATio:ACQuisition:ALOCation[?]
Syntax :PLUGin:ERATio:ACQuisition:ALOCation ‘identifier’, <location-string>
:PLUGin:ERATio:ACQuisition:ALOCation? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
<location-string>: Specify the location identifier or group name identifier.
Return Range <location or group name>
Description This command sets the location identifier (or group name identifier)
against which the data acquisition is performed for the specified
measurement name identifier. The query returns the current location or
group name for the specified measurement name.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.
Example :PLUG:ERAT:ACQ:ALOC ‘MyMeasurement’,“M1.DataIn1”
:RESet :PLUGin:ERATio:RESet on page 298
:STARt :PLUGin:ERATio:STARt on page 298
:STOP :PLUGin:ERATio:STOP on page 300
:SHOW:SGLegends :PLUGin:ERATio:SHOW:SGLegends on
page 300
:GRAPh? :PLUGin:ERATio:GRAPh? on page 300
:RUN:HISTory[:STATe] :PLUGin:ERATio:RUN:HISTory[:STATe][?] on
page 302
:RUN:HISTory:CLEar :PLUGin:ERATio:RUN:HISTory:CLEar on
page 302
:RUN:LOG? :PLUGin:ERATio:RUN:LOG? on page 303
:RUN:MESSage? :PLUGin:ERATio:RUN:MESSage? on page 303
:RUN:PROGress? :PLUGin:ERATio:RUN:PROGress? on page 304
:RUN[:STATus]? :PLUGin:ERATio:RUN[:STATus]? on page 304
Name Description under