480 Keysight M8070A Programming Guide
5 SCPI Command Reference
:DATA:SEQuence Subnode
With this subsystem sequencing can be changed programmatically. For
additional information, refer to Creating Pattern Sequences on page 43.
This subnode has the following SCPI structure:
This subnode has the following commands:
Table 94
Name Description under
:NEW :DATA:SEQuence:NEW on page 482
:NAMes? :DATA:SEQuence:NAMes? on page 482
:BIND[?] :DATA:SEQuence:BIND[?] on page 482
:VALue[?] :DATA:SEQuence:VALue[?] on page 483
:DELete :DATA:SEQuence:DELete on page 484
:DALL :DATA:SEQuence:DALL on page 484
BREak :DATA:SEQuence:BREak on page 484
:DATA
:SEQuence
:NEW
:NAMes?
:BIND[?]
:VALue[?]
:DELete
:DALL
:BREak
:RESTart
:IDENtifier
:BLOCk?
:IDENtifier?
:GRANularity?
:IDENtifier?
To Next Page
Loading...
