Keysight M8190A - Page 114

3 Sequencing
114 M8190A User’s Guide
Trigger Mode Gated
An Offset value is provided after programming. The rising edge of the gate starts the
sequence and plays the sequence infinitely until receiving the falling edge of the gate.
After having received the falling edge of the gate, the sequence is played for a number
of times specified by the sequence loop count. Then the sequence is stopped at its end.
Then the last sample value is provided.
The following segment advancement modes are available:
 Auto
 Conditional (Advancement Event)
 Repeat (Advancement Event)
 Single (Advancement Event)
RUN
Gate
Adv Event Adv Event
Adv Event
Adv Event
Gate
Gate
Offset
Last
Value
a
1
a
1
d
2
a
1
d
2
a
2
a
1
Last
Value
Figure 3-25: Trigger Mode Gated