Data Header
The data header contains the names of the data columns separated by ','. The
waveform data are specified after the data header. This header is optional. If this
header is not specified the data need to be defined similar to CSV files without the
header (see above). The data columns are as follows:
Y1
Waveform data for channel 1.
SyncMarker1
Sync marker for channel 1.
SampleMarker1
Sample Marker for channel 1.
Y2
Waveform data for channel 2.
SyncMarker2
Sync marker for channel 2.
SampleMarker2
Sample Marker for channel 2.
If the file contains data for both channel 1 and 2 it will be treated as I/Q file. If any of
the marker columns (SyncMarker or SampleMarker) is present for a channel the data
header must contain the waveform data column (Y1 or Y2) for that channel. It is
possible to have only the data columns (Y1 , Y2 or both) without the marker columns
though.
Example:
SampleRate = 7.2 GHz
CarrierFrequencyIntegral = 2.0 GHz
CarrierFrequencyFractional = 1 Hz
Y1, SyncMarker1, SampleMarker1, Y2, SyncMarker2, SampleMarker2
0.7, 1, 1, 0.7, 1,1
0.9,1,0,1.0,0,0
Command
:TRAC1:IQIM 1, "C:\Program Files
(x86)\Keysight\M8190\Examples\WaveformDataFiles\Si
n1MHzAt7p68GHz.bin", BIN, IONLY, ON, ALEN
To Next Page
Loading...
