Advancement Event hardware input switch
Enable or disable the advancement event hardware input for channel 1
and channel 2. Advance Event works according to the advancement mode (Auto,
Conditional, Repeat, Single) selected. The advancement event is used to advance
within a scenario or sequence. The advancement event is stored internally until the
sequencer uses it.
For Example:
When receiving an advancement event while executing a conditional segment, the
advancement event is stored until reaching the end of the segment where the
advancement is used. Then the stored advancement event is cleared and the
instrument is able to receive the next one.
When receiving advancement event while executing single segment, the advance
event is provided after each loop is executed.
Amplitude for marker outputs
Specifies the amplitude of the marker output signal.
Offset for marker outputs
Specifies the offset of the marker output signal.
To Next Page
Loading...
