This tab has the following controls:
Waveform Destination Section
Generate I/Q Data
Always checked while in up-converter modes. While in direct mode, it will assign
the I (In-phase) component to Channel 1 and the Q (Quadrature) component to
Channel 2.
Channel
Independent checkboxes allow the definition of standard waveforms for Channel 1,
Channel 2, or both. One of the boxes will be always checked and checking both is
only possible when both channels are coupled (see Channel Coupling control in
Clock Tab).
Segment Number
Target segment for each channel can be defined independently.
To Next Page
Loading...
