Valid Bits
Selects the bit width of the dynamic control port.
AllBits – The complete width of 19 bits is used for segment or sequence selection.
LowerBits – The 13 lowest bits are used for segment or sequence selection. The
upper 6 bits are set to 0.
Select Segment#
Selects the segment to be played in sequencing mode “Arbitrary”. In dynamic
segment selection mode it selects the segment that is played before the first
segment is dynamically selected.
Pressing the “Select..” button opens a list box with the available segments and
their lengths.
Select Sequence ID
Selects the ID of the sequence to be played in sequencing mode “STSequence”. In
dynamic sequence selection mode it selects the sequence that is played before the
first sequence is dynamically selected.
Pressing the “Select..” button opens a list box with the available sequences and
their lengths. This list box only display the sequences defined using the commands
in the Sequence subsystem and not the sequences defined using the commands in
the STABle subsystem.
Run/Stop
Use this button to switch between Run and Program mode per channel.
Force Trigger
Use this button to send a software trigger to a channel.
Force Event
Use this button to send a software event to a channel.
Force Enable
Use this button to send a software “enable” to a channel.
Installed Options
This field displays the installed options of the module.
Installed Licenses
This field displays the installed licenses.
To Next Page
Loading...
