Keysight N6705C - Page 282

FETCh[:SCALar]:CURRent:LOW? (@<chanlist>)
FETCh[:SCALar]:VOLTage:LOW? (@<chanlist>)
Returns the Low level of a pulse waveform. Values returned are either in amperes, or volts. See
Measurement Data Formats. The reading is in the form +n.nnnnnnE+nn for each channel specified.
Multiple responses are separated by commas.
Parameter Typical Return
(none) <LOWvalue>
Returns the measured low level currentFETC:CURR:LOW? (@1)
Returns the measured low level voltage FETC:VOLT:LOW? (@1)
FETCh[:SCALar]:CURRent:MAXimum? (@<chanlist>)
FETCh[:SCALar]:VOLTage:MAXimum? (@<chanlist>)
FETCh[:SCALar]:CURRent:MINimum? (@<chanlist>)
FETCh[:SCALar]:VOLTage:MINimum? (@<chanlist>)
Returns the maximum or minimum value. Values returned are either in amperes, or volts. See
Measurement Data Formats. The reading is in the form +n.nnnnnnE+nn for each channel specified.
Multiple responses are separated by commas.
Parameter Typical Return
(none) <MIN value>
<MAX value>
Returns the measured minimum current FETC:CURR:MIN? (@1)
Returns the measured minimum voltage FETC:VOLT:MIN? (@1)
Returns the measured maximum currentFETC:CURR:MAX? (@1)
Returns the measured maximum voltage FETC:VOLT:MAX? (@1)
FETCh:ARRay:CURRent[:DC]? (@<chanlist>)
FETCh:ARRay:VOLTage[:DC]? (@<chanlist>)
FETCh:ARRay:POWer[:DC]? (@<chanlist>)
Returns an array with the instantaneous measurement.Values are either in amperes, volts, or watts.
The return format depends on the settings of the FORMat:BORDer and FORMat[:DATA] commands.
When the data format is set to ASCII, returned values are comma separated. When the data format is
set to REAL, data is returned as single precision floating point values in definite length arbitrary block
response format.
7 SCPI Programming Reference
282 Keysight N6705C Operating and Service Guide