Keysight N6705C - Page 29

MEASure
[:SCALar]
:CURRent
[:DC]? (@chanlist) Takes a measurement; returns the averaged current.
:ACDC? (@chanlist) Takes a measurement; returns the RMS current (AC + DC).
:HIGH? (@chanlist) Takes a measurement; returns the High level of a current pulse.
:LOW? (@chanlist) Takes a measurement; returns the Low level of a current pulse.
:MAXimum? (@chanlist) Takes a measurement; returns the maximum current.
:MINimum? (@chanlist) Takes a measurement; returns the minimum current.
:POWer
[:DC]? (@chanlist) Takes a measurement; returns the averaged power.
:VOLTage
[:DC]? (@chanlist) Takes a measurement; returns the averaged voltage.
:ACDC? (@chanlist) Takes a measurement; returns the RMS voltage (AC + DC).
:HIGH? (@chanlist) Takes a measurement; returns the High level of a voltage pulse.
:LOW? (@chanlist) Takes a measurement; returns the Low level of a voltage pulse.
:MAXimum? (@chanlist) Takes a measurement; returns the maximum voltage.
:MINimum? (@chanlist) Takes a measurement; returns the minimum voltage.
:ARRAY
:CURRent
[:DC]? (@chanlist) Takes a measurement; returns the instantaneous current.
:POWer
[:DC]? (@chanlist) Takes a measurement; returns the instantaneous power.
:VOLTage
[:DC]? (@chanlist) Takes a measurement; returns the instantaneous voltage.
MMEMory
:ATTRibute? <“object”>, <“attribute”> Gets the attributes of a file system object.
:DATA [:DEFinite]? <“filename”>, <data> Copies file contents; response is a definite length binary block.
:DELete <“filename”> Deletes a file.
:EXPort
:DLOG <“filename”> Exports a data log from the display to a file.
:LOAD
:ARB:SEQuence <“filename”>, (@chanlist) Loads an Arb sequence.
:STORe
:ARB:SEQuence <“filename”>, (@chanlist) Stores an Arb sequence.
OUTPut
[:STATe] 0|OFF|1|ON [,NORelay], (@chanlist) Enables or disables the output.
:COUPle
:CHANnel [<value>, {<value>}] Selects which channels are coupled.
:DOFFset <value> Sets a delay offset to synchronize coupled output state changes.
:MODE AUTO|MANual Specifies the output delay offset coupling mode.
Keysight N6705C Operating and Service Guide 29
1 Quick Reference