:CURRent 0|OFF|1|ON, (@chanlist) Enables/disables current histogram.
:SWEep
:OFFSet
:POINts <value>, (@chanlist) Defines the offset in a data sweep for triggered measurements.
:POINts <value>, (@chanlist) Defines the number of points in a measurement.
:TINTerval <value>, (@chanlist) Defines the time period between measurement samples.
:RESolution RES20|RES40 Sets the measurement resolution.
:VOLTage
[:DC]
:RANGe
[:UPPer] <value>, (@chanlist) Selects a DC voltage measurement range.
:AUTO 0|OFF|1|ON, (@chanlist) Enables/disables seamless measurement autoranging. (N6781A, N6782A)
:WINDow
[:TYPE] HANNing|RECTangular, (@chanlist) Selects the measurement window.
[SOURce:]
ARB
:COUNt? Sets the ARB repeat count.
:CURRent | :VOLTage Specifies current or voltage Arbs
:CDWell
[:LEVel] <value>, {<value>}, (@chanlist) Sets the list of the constant dwell Arb
:DWELl <value>, (@chanlist) Sets the dwell time for the constant dwell Arb
:POINts? (@chanlist) Returns the number of constant-dwell Arb points
:CONVert (@chanlist) Converts the selected Arb to a user-defined list
:EXPonential
:END
[:LEVel] <value>, (@chanlist) Sets the end level of the exponential Arb
:STARt
[:LEVel] <value>, (@chanlist) Sets the initial level of the exponential Arb
:TIMe <value>, (@chanlist) Sets the length of the start time or delay
:TCONstant <value>, (@chanlist) Sets the time constant of the exponential Arb
:TIMe <value>, (@chanlist) Sets the time of the exponential Arb
:PULSe
:END
:TIMe <value>, (@chanlist) Sets the length of the end time
:STARt
[:LEVel] <value>, (@chanlist) Sets the initial level of the pulse
:TIMe <value>, (@chanlist) Sets the length of the start time or delay
:TOP
[:LEVel] <value>, (@chanlist) Sets the top level of the pulse
:TIMe <value>, (@chanlist) Sets the length of the pulse
:RAMP
1 Quick Reference
32 Keysight N6705C Operating and Service Guide
To Next Page
Loading...
