Keysight N6705C - Page 320

SENSe:DLOG:TINTerval <value>
SENSe:DLOG:TINTerval? [MIN|MAX,]
Sets the integration time of the datalog measurement. Values from 1 millisecond to 60 seconds can
be specified
This command has been superseded by SENSe:DLOG:PERiod, but is still available for
backward compatibility.
Parameter Typical Return
0.0002048 to 60|MIN|MAX, *RST 0.1 <datalog period>
Specifies a datalog timeinterval of 0.01 seconds: SENS:DLOG:TINT 0.01, (@1)
l This function cannot be set to values less than 75 milliseconds when interleaved data logging is in
effect.
SENSe:ELOG:CURRent[:DC]:RANGe[:UPPer] <value>, (@<chanlist>)
SENSe:ELOG:CURRent[:DC]:RANGe[:UPPer]? [MIN|MAX,] (@<chanlist>)
SENSe:ELOG:VOLTage[:DC]:RANGe[:UPPer] <value>, (@<chanlist>)
SENSe:ELOG:VOLTage[:DC]:RANGe[:UPPer]? [MIN|MAX,] (@<chanlist>)
Selects the external datalog (Elog) current or voltage measurement range. The value that you enter
must be the highest value that you expect to measure. Units are in amperes or volts. The instrument
selects the range with the best resolution for the value entered.
Parameter Typical Return
0 to maximum|MIN|MAX, *RST MAX <maximum value of range>
Selects the 1 A range: SENS:ELOG:CURR:RANG 1, (@1)
Selects the 2 V range: SENS:ELOG:VOLT:RANG 2, (@1)
l When queried, the returned value is the maximum current or voltage that can be measured on the
range that is presently set.
SENSe:ELOG:CURRent[:DC]:RANGe:AUTO 0|OFF|1|ON, (@<chanlist>)
SENSe:ELOG:CURRent[:DC]:RANGe:AUTO? (@<chanlist>)
SENSe:ELOG:VOLTage[:DC]:RANGe:AUTO 0|OFF|1|ON , (@<chanlist>)
SENSe:ELOG:VOLTage[:DC]:RANGe:AUTO? (@<chanlist>)
Enables/disables seamless Elog measurement autoranging.
7 SCPI Programming Reference
320 Keysight N6705C Operating and Service Guide